Industrial fan controls and wiring

Specify the fan’s power, speed command, feedback and connector by complete part number. Use Hongbo’s product listings to shortlist options, then tie the wiring drawing to the exact sample and order.

12038 Dual Voltage AC Fan
Hongbo 12038 dual-voltage AC product photo. Open the original to inspect the nameplate. Use the applicable wiring document for assembly.

Start with the label and full suffix

Read the supply markings, model code and lead arrangement before bringing a replacement or revised cable into the design. Compare the nameplate to the order, then request the wiring sheet for that version.

Four leads can serve different functions

Hongbo’s 12038 dual-voltage AC listing identifies 110/220 VAC versions with four wires. Those leads belong to the specified mains configuration. A DC fan may also use four leads when separate speed command and feedback are specified. The pin functions come from the drawing for the exact fan.

Separate power, speed command and feedback

Use this checklist when the controller, harness or operating behavior changes. Each item becomes a drawing field or a sample check.

FunctionConfirm with the drawing
PowerInput type, allowed supply range, frequency for AC, running and starting current, and protective earth where applicable.
Speed commandPWM level, reference, frequency and duty range, or the supported analog voltage and its speed correspondence. Confirm startup and the state with command absent.
Feedback / faultDistinguish a tachometer pulse output from an alarm output. Confirm the output circuit, external load or pull-up requirements, pulse count and expected fault state.
Digital interfaceWhen specified, request the supported communications settings, addresses and register documentation for the controller and fan variant.
HarnessConnector and mating part, keyed orientation, pin functions, lead length, routing and the drawing revision for the supplied assembly.

Example to specify

If the equipment controller sends PWM and reads actual speed, request both the compatible PWM input and a tachometer output with its electrical limits. Specify startup, minimum speed and what the controller should see if feedback is lost.

Find the family, then confirm the available suffix

Hongbo publishes some control options at family level. Match them to the quoted electrical variant and drawing before changing the harness or control logic.

8025 DC

80 × 80 × 25 mm

The DC family lists voltage options and offers PWM on selected versions. Ask which specific suffix supports the requested power rail and control or monitoring interface.

12038 EC

120 × 120 × 38 mm

0–10 V and PWM are listed as family options. Confirm power input, command type and signal reference on the proposed unit, and ask for separate feedback specifications if needed.

12038-5P AC

AC catalogue reference

Use the electrical designation and actual frequency when matching a standard AC replacement. The file centre includes a catalogue extract and a request for the current drawing.

Check the sample before release

  1. Match the build. Record the sample suffix, label, connector and drawing revision. Confirm pin functions and lead reach in the installed equipment.
  2. Verify operation. With the specified controller and approved test setup, check startup, the normal range and the commanded mode. Compare actual feedback with the expected output.
  3. Record the result. Note the supply, configuration and observed speed or alarm response. File a signed-off harness drawing and sample reference with the production order.
Hongbo 12038 five-blade AC axial fan with its nameplate visible
12038-5P AC product label. Keep the ordered model and drawing revision with the sample record.

Request the drawing for your exact configuration

Attach the fan label, mating connector or controller specification when you send the draft. Enter the input supply, speed command, feedback and lead requirements so the requested document can be matched to the correct part.

Scroll to Top

Get A Free Quote Now !

Contact Form
If you have any questions, please do not hesitate to contact us.
changfang